1 / 1
Unfitted glass is fragile. Do not place on hard surfaces prior to fitting. Special care should be taken with the corners of the product as impact will cause the product to crack.
To prevent product failures ensure that:
All fitting steps are completed.
A space of at least 2mm is left between the product and all surfaces.
The gaps must be filled with silicone.
The surface to which the product is applied is flat, variations in level in excess of 5mm should be packed with silicone prior to fitting.
You do not use any form of adhesive other than silicone as certain adhesives will degrade the finish of the glass.
SAFE HANDLING OF GLASS
All products are supplied with a safety backing but we recommend that glass is handled with care and in particular eye protection and suitable gloves should be worn.
Do not use abrasive cleaners. For the best results use:
Hot water with a mild soap detergent.
BEFORE YOU START
Check that all components are present.
Ensure that you have all tools to hand.
TOOLS NEEDED TO FIT THE SPLASH BACK
Silicone sealant - only use LM or AC.(Our Splashbacks are self adhesive, the Silicone Sealant is for sealing gaps only)
2mm tile spacers.
Do you have everything you need to start the job?
Check that the splash back fits.
Ensure that your worktop is fitted securely.
Check that your worktop is level.
Clear all dust from the worktop.
Ensure that your hob is fitted in accordance with the manufacturer's instructions and that the clearance between the hob and splash back complies with the appliance manufacturer's instructions.
Make sure that your extractor is securely fitted in accordance with the manufacturer's instructions.
Fit the splash back directly onto a hob or work surface useing spacers.
Place the splash back on its edge on any hard surface during the fitting process.
Use the product until the silicone has cured
(follow the manufacturer's instructions).
No Reviews Found
No Questions yet